Nissan Qashqai J10 +2 LED brake light repair kit B003339 B B003338 B
Description
If your reading this then it is likely your brake light has failed or started failing / flickering? This is a common issue that can be cheaply repaired with the correct tools and skill set.
Maybe your car has failed its MOT because of a high percentage of flickering or missing LED in the brake light LED board that sits inside the light unit and is easily to remove.
The fault is usually cause by burnt out / corroded LED caused by years of direct sunlight lifespan ,dry internal resistors or water ingress.
PCB Image below shows typical corrosion
I have 2 options to repair this issue
Option one
A complete replacement circuit board that simply needs the female spade connectors re-pinning your original plug with no need to solder
I have a guide showing how to re-pin the original plug on YouTube in the link HERE
Option two
A DIY repair kit that requires quite extensive soldering
I have a guide showing the solder process on YouTube in the link HERE
What is in the DIY repair kit?
12pcs of LED chip
28pcs SMD resistor
10pcs Capacitor
Enough components to rebuild the entire bottom half of the board and replace all the LED

Warranty
Replacement PCB comes with a 1yr warranty against failure (Please note evidence of water ingress/corrosion to PCB or components is not covered)
Reviews
-
Nissan qashqai rear light led
Excellent product and service
-
nissan n/s/r j10 led brake lamp
excellent 1st class part
-
Led Brake Light Repair Nissen Qashqai
Arrived on time. Packaged very well. product works fab. Would buy again from this seller
-
Nissan brake light led circuit board
After first ordering the led repair kit and realising that I do not have the skills to solder the individual led's into place I was able to order the complete led circuit board. Great product and great advice and service from Michael.